دورية أكاديمية

Компьютерное моделирование реактора для высокотемпературного адиабатического нитрования бензола ; Computer simulation of a reactor for high-temperature adiabatic nitration of benzene

التفاصيل البيبلوغرافية
العنوان: Компьютерное моделирование реактора для высокотемпературного адиабатического нитрования бензола ; Computer simulation of a reactor for high-temperature adiabatic nitration of benzene
المؤلفون: Кондратов, Сергей Алексеевич, Красильникова, Анна Александровна
بيانات النشر: НТУ "ХПИ"
سنة النشر: 2017
المجموعة: Electronic National Technical University "Kharkiv Polytechnic Institute" Institutional Repository (eNTUKhPIIR) / електронному репозитарії Національного технічного університету "Харківський політехнічний інститут"
مصطلحات موضوعية: реактор идеального вытеснения, математические модели, ячеечная модель, гетерогенное нитрирование, ideal tubular reactor, mathematical models, cell model
الوصف: Рассмотрены две модели реактора высокотемпературного адиабатического нитрования бензола: "мягкая" модель, основанная на кинетике гетерогенного нитрования в условиях идеального перемешивания, и упрощенная ячеечная модель, Обе модели позволяют грубо оценить границы времени пребывания для достижения высокой степени превращения в реакторе вытеснения в процессе высокотемпературного адиабатического нитрования бензола. Модели могут быть использованы при проектировании опытных установок высокотемпературного адиабатического нитрования. ; A "soft" model of the ideal tubular reactor with mixing elements for the process of high-temperature adiabatic nitration of benzene in the mixture of HNO₃-H₂SO₄-H₂O has been developed. This model makes it possible to estimate roughly the boundaries of the residence time to achieve a high degree of conversion. The standard model of a tubular piston flow adiabatic reactor in the stationary state was used. The model is based on the kinetic data of heterogeneous nitration under ideal mixing conditions and the parameter that characterizes the delamination. It was shown by modeling that in the range of operating temperatures of nitration of 100-150 °C and a degree of conversion of 0-100%, the density change does not exceed 3% rel. It is possible to regard the density as constant in the first approximation. The upper and lower limits of the values of this parameter can be chosen empirically. A simplified cell model of high-temperature adiabatic nitration was proposed. The model is based on the next assumption. The emulsion in the cell is stratified after mixing. As a result, the average volume fraction of the emulsion in the mixture becomes less than 1. It has been suggested that this amount of emulsion fully reacts in the cell. Next, mixing and transition to the next cell occurs. A satisfactory correspondence between the results of the model calculation and the literature data was demonstrated. The developed models can be used to design research facilities for high-temperature adiabatic ...
نوع الوثيقة: article in journal/newspaper
وصف الملف: application/pdf
اللغة: Russian
العلاقة: Кондратов С. А. Компьютерное моделирование реактора для высокотемпературного адиабатического нитрования бензола / С. А. Кондратов, А. А. Красильникова // Вісник Нац. техн. ун-ту "ХПІ" : зб. наук. пр. Сер. : Нові рішення в сучасних технологіях = Bulletin of National Technical University "KhPI" : coll. of sci. papers. Ser. : New solutions in modern technologies. – Харків : НТУ "ХПІ", 2017. – № 23 (1245). – С. 150-157.; http://repository.kpi.kharkov.ua/handle/KhPI-Press/31985Test
DOI: 10.20998/2413-4295.2017.23.24
الإتاحة: https://doi.org/10.20998/2413-4295.2017.23.24Test
http://repository.kpi.kharkov.ua/handle/KhPI-Press/31985Test
رقم الانضمام: edsbas.36FFC676
قاعدة البيانات: BASE