التفاصيل البيبلوغرافية
| العنوان: |
Effects of Finish Line Design and Fatigue Cyclic Loading on Phase Transformation of Zirconia Dental Ceramics: A Qualitative Micro-Raman Spectroscopic Analysis. |
| المؤلفون: |
Sorrentino, Roberto1 errestino@libero.itzarone@unina.it, Navarra, Chiara Ottavia2 c.navarra@fmc.units.it, Di Lenarda, Roberto2 rdilenarda@units.it, Breschi, Lorenzo3 lorenzo.breschi@unibo.it, Zarone, Fernando1 gspagnuo@unina.it, Cadenaro, Milena2 mcadenaro@units.it, Spagnuolo, Gianrico1 |
| المصدر: |
Materials (1996-1944). 3/15/2019, Vol. 12 Issue 6, p863-863. 1p. 4 Diagrams, 1 Chart, 1 Graph. |
| مصطلحات موضوعية: |
*CYCLIC loads, *ZIRCONIUM oxide, *PHASE transitions, *MONOCLINIC crystal system, *MILLING (Metalwork) |
| مستخلص: |
Objectives: Stresses produced during the fabrication of copings and by chewing activity can induce a tetragonal-to-monoclinic (t–m) transformation of zirconia. As a consequence, in the m-phase, the material is not able to hinder possible cracks by the favorable mechanism known as "transformation toughening". This study aimed at evaluating if different marginal preparations of zirconia copings can cause a premature phase transformation immediately after manufacturing milling and after chewing simulation. Methods: Ninety copings using three commercial zirconia ceramics (Nobel Procera Zirconia, Nobel Biocare Management AG; Lava Classic, 3M ESPE; Lava Plus, 3M ESPE) were prepared with deep-chamfer, slight-chamfer, or feather-edge finish lines (n = 10). Specimens were tested in a chewing simulator (CS-4.4, SD Mechatronik) under cyclic occlusal loads simulating one year of clinical service. Raman spectra were acquired and analyzed for each specimen along the finish lines and at the top of each coping before and after chewing simulation, respectively. Results: Raman analysis did not show any t–m transformation both before and after chewing simulation, as the typical monoclinic bands at 181 cm−1 and 192 cm−1 were not detected in any of the tested specimens. Conclusions: After a one-year simulation of chewing activity, irrespective of preparation geometry, zirconia copings did not show any sign of t–m transformation, either in the load application areas or at the margins. Consequently, manufacturing milling even in thin thickness did not cause any structural modification of zirconia ceramics "as received by manufacturers" both before and after chewing simulation. [ABSTRACT FROM AUTHOR] |
| قاعدة البيانات: |
Academic Search Index |
Full Text Finder