التفاصيل البيبلوغرافية
| العنوان: |
Ultrafast-laser dicing of thin silicon wafers: strategies to improve front- and backside breaking strength. |
| المؤلفون: |
Domke, Matthias1 matthias.domke@fhv.at, Egle, Bernadette2, Stroj, Sandra1, Bodea, Marius3, Schwarz, Elisabeth3, Fasching, Gernot4 |
| المصدر: |
Applied Physics A: Materials Science & Processing. Dec2017, Vol. 123 Issue 12, p1-8. 8p. 2 Diagrams, 3 Graphs. |
| مصطلحات موضوعية: |
*SILICON wafers, *LASER beams, *HEAT losses, *POWER density, *METALLIZING, *BENDING strength |
| مستخلص: |
Thin 50-µm silicon wafers are used to improve heat dissipation of chips with high power densities. However, mechanical dicing methods cause chipping at the edges of the separated dies that reduce the mechanical stability. Thermal load changes may then lead to sudden chip failure. Recent investigations showed that the mechanical stability of the cut chips could be increased using ultrashort-pulsed lasers, but only at the laser entrance (front) side and not at the exit (back) side. The goal of this study was to find strategies to improve both front- and backside breaking strength of chips that were cut out of an 8″ wafer with power metallization using an ultrafast laser. In a first experiment, chips were cut by scanning the laser beam in single lines across the wafer using varying fluencies and scan speeds. Three-point bending tests of the cut chips were performed to measure front and backside breaking strengths. The results showed that the breaking strength of both sides increased with decreasing accumulated fluence per scan. Maximum breaking strengths of about 1100 MPa were achieved at the front side, but only below 600 MPa were measured for the backside. A second experiment was carried out to optimize the backside breaking strength. Here, parallel line scans to increase the distance between separated dies and step cuts to minimize the effect of decreasing fluence during scribing were performed. Bending tests revealed that breaking strengths of about 1100 MPa could be achieved also on the backside using the step cut. A reason for the superior performance could be found by calculating the fluence absorbed by the sidewalls. The calculations suggested that an optimal fluence level to minimize thermal side effects and periodic surface structures was achieved due to the step cut. Remarkably, the best breaking strengths values achieved in this study were even higher than the values obtained on state of the art ns-laser and mechanical dicing machines. This is the first study to the knowledge of the authors, which demonstrates that ultrafast-laser dicing improves the mechanical stability of thin silicon chips. [ABSTRACT FROM AUTHOR] |
| قاعدة البيانات: |
Academic Search Index |
